Request for Comments: 6164
Category: Standards Track
Juniper Networks, Keio University
Internet Initiative Japan
Using 127-Bit IPv6 Prefixes on Inter-Router Links
On inter-router point-to-point links, it is useful, for security and other reasons, to use 127-bit IPv6 prefixes. Such a practice parallels the use of 31-bit prefixes in IPv4. This document specifies the motivation for, and usages of, 127-bit IPv6 prefix lengths on inter-router point-to-point links.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 5741.
Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc6164.
Copyright © 2011 IETF Trust and the persons identified as the document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.
Table of Contents
1. Introduction ....................................................2 2. Scope of This Memo ..............................................3 3. Conventions Used in This Document ...............................3 4. Problems Identified with 127-Bit Prefix Lengths in the Past .....3 5. Reasons for Using Longer Prefixes ...............................4 5.1. Ping-Pong Issue ............................................4 5.2. Neighbor Cache Exhaustion Issue ............................4 5.3. Other Reasons ..............................................5 6. Recommendations .................................................5 7. Security Considerations .........................................6 8. Contributors ....................................................6 9. Acknowledgments .................................................6 10. References .....................................................6 10.1. Normative References ......................................6 10.2. Informative References ....................................7
[RFC4291] specifies that interface IDs for all unicast addresses, except those that start with the binary value 000, are required to be 64 bits long and to be constructed in Modified EUI-64 format. In addition, it defines the Subnet-Router anycast address, which is intended to be used for applications where a node needs to communicate with any one of the set of routers on a link.
Some operators have been using 127-bit prefixes, but this has been discouraged due to conflicts with Subnet-Router anycast [RFC3627]. However, using 64-bit prefixes creates security issues that are particularly problematic on inter-router links, and there are other valid reasons to use prefixes longer than 64 bits, in particular /127 (see Section 5).
This document provides a rationale for using 127-bit prefix lengths, reevaluates the reasons why doing so was considered harmful, and specifies how /127 prefixes can be used on inter-router links configured for use as point-to-point links.
2. Scope of This Memo
This document is applicable to cases where operators assign specific addresses on inter-router point-to-point links and do not rely on link-local addresses. Many operators assign specific addresses for the purposes of network monitoring, reverse DNS resolution for traceroute and other management tools, External Border Gateway Protocol (EBGP) [RFC4271] peering sessions, and so on.
For the purposes of this document, an inter-router point-to-point link is a link to which only two routers and no hosts are attached. This may include Ethernet links that are configured to be point-to- point. Links between a router and a host, or links to which both routers and hosts are attached, are out of scope of this document.
The recommendations in this document do not apply to the link-local address scope.
3. Conventions Used in This Document
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119].
4. Problems Identified with 127-Bit Prefix Lengths in the Past
[RFC3627] discourages the use of 127-bit prefix lengths due to conflicts with the Subnet-Router anycast addresses, while stating that the utility of Subnet-Router anycast for point-to-point links is questionable.
[RFC5375] also says the usage of 127-bit prefix lengths is not valid and should be strongly discouraged, but the stated reason for doing this is to be in compliance with [RFC3627].
Though the analyses in the RFCs are correct, operational experience with IPv6 has shown that /127 prefixes can be used successfully.
5. Reasons for Using Longer Prefixes
There are reasons network operators use IPv6 prefix lengths greater than 64, particularly 127, for inter-router point-to-point links.
5.1. Ping-Pong Issue
A forwarding loop may occur on a point-to-point link with a prefix length shorter than 127. This does not affect interfaces that perform Neighbor Discovery, but some point-to-point links, which use a medium such as the Synchronous Optical Network (SONET), do not use Neighbor Discovery. As a consequence, configuring any prefix length shorter than 127 bits on these links can create an attack vector in the network.
The ping-pong issue happens in the case of IPv4 as well. But due to the scarcity of IPv4 address space, the current practice is to assign long prefix lengths such as /30 or /31 [RFC3021] on point-to-point links; thus, the problem did not come to the fore.
The latest ICMPv6 specification [RFC4443] mitigates this problem by specifying that a router receiving a packet on a point-to-point link, where the packet is destined to an address within a subnet assigned to that same link (other than one of the receiving router's own addresses), MUST NOT forward the packet back on that link. Instead, it SHOULD generate an ICMPv6 Destination Unreachable message (code 3) in response. This check is on the forwarding processing path, so it may have performance impact.
5.2. Neighbor Cache Exhaustion Issue
As described in Section 4.3.2 of [RFC3756], the use of a 64-bit prefix length on an inter-router link that uses Neighbor Discovery (e.g., Ethernet) potentially allows for denial-of-service attacks on the routers on the link.
Consider an Ethernet link between two routers, A and B, to which a /64 subnet has been assigned. A packet sent to any address on the /64 (except the addresses of A and B) will cause the router attempting to forward it to create a new cache entry in INCOMPLETE state, send a Neighbor Solicitation message on the link, start a retransmit timer, and so on [RFC4861].
By sending a continuous stream of packets to a large number of the 2^64 - 3 unassigned addresses on the link (one for each router and one for Subnet-Router anycast), an attacker can create a large number of neighbor cache entries and cause one of the routers to send a large number of Neighbor Solicitation packets that will never receive replies, thereby consuming large amounts of memory and processing resources. Sending the packets to one of the 2^24 addresses on the link that has the same Solicited-Node multicast address as one of the routers also causes the victim to spend large amounts of processing time discarding useless Neighbor Solicitation messages.
Careful implementation and rate-limiting can limit the impact of such an attack, but are unlikely to neutralize it completely. Rate- limiting Neighbor Solicitation messages will reduce CPU usage, and following the garbage-collection recommendations in [RFC4861] will maintain reachability, but if the link is down and neighbor cache entries have expired while the attack is ongoing, legitimate traffic (for example, BGP sessions) over the link might never be re-established, because the routers cannot resolve each others' IPv6 addresses to link-layer addresses.
This attack is not specific to point-to-point links, but is particularly harmful in the case of point-to-point backbone links, which may carry large amounts of traffic to many destinations over long distances.
While there are a number of ways to mitigate this kind of issue, assigning /127 subnets eliminates it completely.
5.3. Other Reasons
Though address space conservation considerations are less important for IPv6 than they are in IPv4, some operators prefer not to assign /64s to individual point-to-point links. Instead, they may be able to number all of their point-to-point links out of a single /64 or a small number of /64s.
Routers MUST support the assignment of /127 prefixes on point-to- point inter-router links. Routers MUST disable Subnet-Router anycast for the prefix when /127 prefixes are used.
When assigning and using any /127 prefixes, the following considerations apply. Some addresses have special meanings, in particular addresses corresponding to reserved anycast addresses. When assigning prefixes (and addresses) to links, care should be taken to ensure that addresses reserved for such purposes aren't inadvertently assigned and used as unicast addresses. Otherwise, nodes may receive packets that they are not intended to receive. Specifically, assuming that a number of point-to-point links will be numbered out of a single /64 prefix:
(a) Addresses with all zeros in the rightmost 64 bits SHOULD NOT be
assigned as unicast addresses, to avoid colliding with the Subnet-Router anycast address [RFC4291].
(b) Addresses in which the rightmost 64 bits are assigned the
highest 128 values (i.e., ffff:ffff:ffff:ff7f to ffff:ffff:ffff:
ffff) SHOULD NOT be used as unicast addresses, to avoid
colliding with reserved subnet anycast addresses [RFC2526].
7. Security Considerations
This document does not have inherent security considerations. It does discuss security-related issues and proposes a solution to them.
Chris Morrow, firstname.lastname@example.org Pekka Savola, email@example.com Remi Despres, firstname.lastname@example.org Seiichi Kawamura, email@example.com
The authors would like to thank Ron Bonica, Pramod Srinivasan, Olivier Vautrin, Tomoya Yoshida, Warren Kumari, and Tatsuya Jinmei for their helpful inputs.
10.1. Normative References
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC4291] Hinden, R. and S. Deering, "IP Version 6 Addressing Architecture", RFC 4291, February 2006. [RFC4861] Narten, T., Nordmark, E., Simpson, W., and H. Soliman, "Neighbor Discovery for IP version 6 (IPv6)", RFC 4861, September 2007.
10.2. Informative References
[RFC2526] Johnson, D. and S. Deering, "Reserved IPv6 Subnet Anycast Addresses", RFC 2526, March 1999. [RFC3021] Retana, A., White, R., Fuller, V., and D. McPherson, "Using 31-Bit Prefixes on IPv4 Point-to-Point Links", RFC 3021, December 2000. [RFC3627] Savola, P., "Use of /127 Prefix Length Between Routers Considered Harmful", RFC 3627, September 2003. [RFC3756] Nikander, P., Ed., Kempf, J., and E. Nordmark, "IPv6 Neighbor Discovery (ND) Trust Models and Threats", RFC 3756, May 2004. [RFC4271] Rekhter, Y., Ed., Li, T., Ed., and S. Hares, Ed., "A Border Gateway Protocol 4 (BGP-4)", RFC 4271, January 2006. [RFC4443] Conta, A., Deering, S., and M. Gupta, Ed., "Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6) Specification", RFC 4443, March 2006. [RFC5375] Van de Velde, G., Popoviciu, C., Chown, T., Bonness, O., and C. Hahn, "IPv6 Unicast Address Assignment Considerations", RFC 5375, December 2008.
Miya Kohno Juniper Networks, Keio University Shinjuku Park Tower, 3-7-1 Nishishinjuku Shinjuku-ku, Tokyo 163-1035 Japan
firstname.lastname@example.org Becca Nitzan Juniper Networks 1194 North Mathilda Avenue Sunnyvale, CA 94089 USA
email@example.com Randy Bush Internet Initiative Japan 5147 Crystal Springs Bainbridge Island, WA 98110 USA
Internet Initiative Japan
Jinbocho Mitsui Building
1-105 Kanda Jinbo-cho, Tokyo 101-0051
EMail: firstname.lastname@example.org Lorenzo Colitti Google 1600 Amphitheatre Parkway Mountain View, CA 94043 USA
email@example.com Thomas Narten IBM Corporation 3039 Cornwallis Ave. PO Box 12195 Research Triangle Park, NC 27709-2195 USA EMail: firstname.lastname@example.org